How to factory reset a network recorder Gigamedia

Modified on Fri, 9 Jun, 2023 at 10:01 AM

To restore the default settings of your recorder, you must have the password,

ATTENTION, perform this manipulation only if you have the ability to reinstall the entire installation or at the request of a technician.

Go to System > maintenance > load default

Check the settings you want to restore.

Channel: IP camera channels configured and added to the recorder

Save: encoding settings, resolution, and OSD

Alarm: parameters on alarms, actions on detection, input output dry contact...

Network: IP address, ports...

Storage: cloud settings, recording time, FTP...

System: language configuration, recorder display, password, and users...

Then apply, then enter the password, the recorder will restart.