Access Control : How to RESET control unit with SW1 & SW2 buttons ?

Modified on Thu, 30 Dec, 2021 at 3:27 PM






SW1 to erase memory of the control unit :

- Power off the control Unit.  

- Hold SW1 Swtich while restoring Power.  

- Wait for the blue LED on the expansion bus to light up (approximately 10 seconds) while holding the switch down.

- Release SW1




SW2 to restore factory network settings (IP address : 192.168.2.150, mask 255.255.255.0). 

- Power off the control Unit.   

- Keep the switch pressed while turning the power back on.



Remark 


- To configure the control unit with a fixed IP address, release the switch at the first flash of the extension bus LED (about 5 seconds).

To configure the control unit in DHCP mode, wait for the second flash of the extension bus LED (approximately 5 seconds after the first flash).

Release SW2 

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article