GGM WAPRAX – How to configure Repeater Mode

 GGM WAPRAX – How to configure Repeater Mode

Using WEB browser 

Plug the extender and wait until the Power LED turns solid on. 

Connect your computer or smartphone to the extender’s network named fggm-extender (or here Ggm AP5G)

Launch a web browser and enter http://ggm-ext.net/

or http://192.168.10.254/ in the address bar. 

Use admin for password to log in.

Step 1 : 

Choose Operation Mode as Wireless Extender (or Repeater). Then click Next

Step 2 : Select your Time Zone

Step 3 : Scan and select an existing network that you would like to extend then Connect

Enter the WIFI password (Security Key) for your existing network :

Step 4 : Set the extended network names (SSIDs) then Apply

Note : The extended network’s password is the same as your host network

Device is restarting and will take about 1 minute

Repeater is now ready to use

Using WPS Button

Plug the extender next to your router and wait until the Power LED turns solid on. (1 minute)

Press  the WPS button on your router and then the WPS button on the extender within 2 minutes

WPS LED starts flashing. 

When WPS LED and WIFI LED turn solid on, it means the extender is connected to your host WIFI Network 

Repeater is now ready to use